ploggZgb EAP for remote access to permanent or semi-permanent installations

The Ethernet Access Point is a gateway which allows access to ZigBee mesh networking modules over an industry standard Ethernet IP Network. In addition, once the IP address of the EAP has been established and Firewalls permitting, the EAP can be accessed from anywhere in the world.


zgb EAP network diagram

ploggZgb EAP Features

Module Features

  • Combines a Telegesis ETRX2 module with a Lantronix serial to Ethernet bridge
  • Complete TCP/IP protocol stack and Windows deployment software
  • Interface: Ethernet 10Base-T or 100Base-TX (Auto-Sensing)
  • Protocols: TCP/IP, UDP/IP, ARP, ICMP, TFTP, Telnet, Auto IP, DHCP
  • Management: Telnet and Microsoft Windows® based utility for configuration
  • Can offer access to the remote AT-Command Inteface via a serial Com port
  • SIF interface for Custom application development and real time debugging of custom firmware
  • External power supply required

Software Features

  • Device deployment and network initiation are simplified with Dynamic Host Protocol Support (DHCP) and additional IP configuration methods via the included Windows® based Lantronix Device Installer software.
  • Supported Com Port Redirector (CPR) software maps virtual COM ports on a PC platform and redirects application data destined to an attached device. Rather than going out of the local COM port, the data is transmitted across the Ethernet network to/from the Lantronics XPort Direct using TCP/IP.

see our other products (click below)